When I Installed my FI 14'' CB. I added 3 washers between one of my hangers and the body. Using it as a spacer so the muffler would sit lower in the cutout. My tips were not even and it bugged TF outta me!!! I wouldn't pull them futher out because Kevin @ FI has told me horror stories of them eventually coming apart :0 Told me only a half inch outta the slip fit at most! They are only adjustable side to side. (Left to Right) Mine are 3/4 of an inch from the diffuser. Haven't Melted yet!
Diffuser help
I test fit a polyU diffuser before I have it painted, and it looks like the FI exhaust tips will sit ~3/4” inside of the diffuser. When FI installed their 14” touring kit, they said that it is already extended as much as it should be. I’m sure I can lower the tips a little by adjusting the hanger brackets, but I’m worried that the hot exhaust gasses will melt the diffuser. Do you think I have anything to worry about?
FYI, this is just a test fit, and the ends aren’t fully secured.
![Vehicle Car Hood Automotive tire Automotive lighting]()
FYI, this is just a test fit, and the ends aren’t fully secured.
