Infiniti Q60 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Good day everyone, excuse me if this is not the place to post my issue but this is my first time on the forum, so I recently bought a 2018 q60 3.0t that was repaired, and the car is terrific, asides from one small issue. I noticed that both my front seatbelts had issues retracting and so I opened up the the rear panel to get a look at the retractor and I could see that the connectors that are supposed to attach to the pretensioners have been cut, which leads me to believe that the pretensioners are also probably blown. Now I managed to get my hands on a pair of functioning seatbelts and some salvaged some yellow and orange connectors but my issue is that I'm not sure what the polarity is supposed to be, if anyone has a picture of how the connector is wired up or a wiring diagram relating the seatbelt pretensioners system that would greatly help me out, thank you all in advance
 

·
Super Moderator
Joined
·
3,015 Posts
Welcome
 
1 - 2 of 2 Posts
Top